Jumper R8 16CH RC Receiver Compatible T16 FrSky D16 D8 Mode Support PIX PX4 APM Flight Controller PWM SBUS Output
The Jumper R8 is a 2.4Ghz receiver that integrates MAVlink telemetry so you can show data from your Pixhawk/PX4 drone on your compatible radio like the Jumper T16, or Frsky Taranis.
The R8 receiver is the first receiver that can directly transmit the PIX and PX4 flight control data to your R/C controller. This can be used to display the flight control data directly on your radio. Apart from this is it just like any other 8 channel SBUS/PWM R/C receiver. Bottom line if you are looking for an R/C link to your Pixhawk drone, this is the receiver you should consider.
1-8 channels from traditional channel output, 1-16 channels from SBUS port
RSSI output: analog voltage output (03.3V)
Two-way full duplex transmission (Telemetry)
With RSSI output: analog voltage output (03.3V)
Number of channels: 8ch (PWM) / 16ch (SBUS)
RSSI (Signal Strength Indication) output: PWM
Operating voltage range: 4.0~8.4V
Operating current range: 100mA@5V
Effective distance: full distance (>2.0km)
Yaapu Telemetry Script
Ardupilot WIki on telemetry setup
1. Press the bind button on the receiver, red/green LED solid on
2. On radio side, select Frsky D16 protocol (T12/T16: Multi Frsky D16);
3.When Red LED is flashing, binding succeeded.
4. After binding, withdraw the binding mode and power up the receiver again. Green Led turns solid on.
LED Colours and meaning
the green light is always on: the signal is good.
the green light is blinking: the signal is bad.
the red light is always on: the signal is lost.
If you fly Fixed Wing Airplanes and went to jump into the open tx game, this receiver if should be your 1st choice. This Jumper R8 naturally works perfect with the Jumper T16 as well as any other transmitter which can bind to D8 or D16. This receiver has more then enough range for the parkflyer and has 8 usable channels. Works as any other fixed wing receiver, so setup is a breeze.
1 x R8 Receiver